Adjustable Bathroom Colour Changing and CCT Low Glare Downlight

An updated package of our remote control colour changing lamps including a high-quality adjustable die-cast aluminium housing suitable for use in your bathroom as this is IP65 Rated.

Now available in a choice of 2 different finishes.

Low glare, as the lamp sits higher up in the downlight.

20º adjustability - This is easily done by removing the front bezel, find the correct angle you require and screw back the bezel.

The perfect mood enhancement for your bathroom. Containing the latest in colour changing LED technology providing infinite adjustment of speed and colours - up to 1.2 million static colours all of which are dimmable down to 10%. 

CCT - by use of the remote you are able to select the colour temperature of the white mode, from soft warm white (2700k) all the way to Daylight white (6500k)

The lamp has a life span of approximately 50,000 hours.

Although this fitting requires remote control for use, if it is fitted as part of your mains wall light switched circuit it will resume from its last known state when switched on.

The receiver is built into the lamp, Unlike older IR RGB lamps where you would need to hold the remote close to the lamp. This Elite lamp uses RF (radio frequency) with a multi-directional remote, this means the remote would change the colours easily anywhere in the room.  We've tested this, we managed to keep changing the colours in a different room. 

Each lamp can be paired to one of eight lighting channels. This allows individually switched scenes within a room can be controlled by one remote.

The kit consists of a colour change lamp, die-cast aluminium housing and a GU10 lamp holder. You are only going to need one remote control so just order one kit complete with remote as below, and then as many additional kits as you require without the remote. Simples. 

Remote holder supplied, so no chance of losing the remote.

To Sync (link) - Turn the lamps on and triple(3) press the zone button you wish the lamp(s) to be assigned to, to unlink press the zone button five(5) times.

We also list the downlight individually. This allows you to install a normal white LED or halogen lamp and have them match the style of your colour changing fittings.

Quick Sync Guide:

• To Sync a zone - Power on at the mains, press the corresponding zone button 5 times in quick succession.
• To Unsync a zone - Power on at the mains, press the corresponding zone button 10 times in quick succession.
• To control all zones, hit the M (Master) button.