A small LED marker light constructed of high-quality 316 marine grade stainless steel making this a great choice for ground lights with lots of potential foot traffic.

Suitable for both interior or exterior use, whether it be for demarcation in corridors, low-level lighting in bathrooms or providing subtle lighting where you want it.

Offered here in two colour temperatures 3000°k (warm white) and 4000°k (neutral white), providing a soft 40 lumens or 50 lumens respectively.

IP67 rated giving protection against powerful projection of water and partial immersion. The bezel is marine 316l stainless steel.

The LED chip is rated at 0.6 watts, so several can be used on a single 12 DC power supply.

Cable length included is 500mm and can easily be extended as required.

Cut-out Diameter:
25mm

Overall Diameter:
30mm

Lamp Type	Long Life LED Light Source
Dimmable?	Yes - when used with a dimmable LED driver
Total Wattage	0.6w
Diameter	30mm
Depth/Projection	30mm
Cut-Out Diameter	25mm
Construction	Stainless Steel marine grade 316
Wiring Details	Class 3 - Requires a low voltage supply
IP Rating	IP67
Driver	No driver or transformer is supplied with this fixture (sold separately)

I want to fit 3 of these in a bathroom niche, do I need to buy 3 power supplies or only one power supply to power 3 bulbs?
One power supply will be sufficient of they are in the same niche.

Hi. I can I chose to have a 5000 colour when ordering? What drivers do I need with these?
I'm afraid these only come in 3 & 4k. The lights are .6w each so if you have up to 10 lights, you'll need a 6w driver or above...up to 20 lights, a 12w driver or above.

What size and type of wire should be used to extend the 300mm length cable supplied with the lights?
0.5 mm 2-core flex would work or larger if you have something to hand. If the joint needs to be water resistant you might want to solder and cover in heat shrink over wise a screw connector block or Wago would be sufficient.

I’m having a shower niche installed inside my shower cubicle. Are these lights ok to install into the niche please?
Yes, this product is ideal for you application with a high IP rating and a corrosion resistant finish.

Is this up lighter suitable for bathroom floor? When the bulb does go, can it be changed easily?
This recessed up light has an IP67 rating making it safe for bathrooms as it can withstand temporary water immersion (we would always suggest you consult an electrician for advice). The illumination comes from an integrated LED chip and therefore has an extended lamp life period.

Can these be fitted in the ceiling in a shower area?
Yes. These are suitable for bathroom zones 1, 2 and 3.