4-Channel RF Remote and LED Controller for White and CCT Adjustable LED Strip Lights

Operating your lighting doesn't require a remote control. LED strips can be linked to a switch for straightforward on/off functionality. Alternatively, opting for a dimmable LED driver enables you to replace the wall switch with a phase-cut rotary dimmer.

For a handheld control option, wire a receiver between a non-dimmable driver and your LED tape. This receiver fine-tunes the voltage to your installed LED lights, allowing you to adjust the light level. When leaving the room, use the remote or wall switch to turn off the light. Upon returning, switch on, and your lights illuminate at the previously selected light level.

Our offering includes a remote control with one receiver, capable of handling a 24-volt load of up to 144 watts on a single receiver.

Additional receivers are available for purchase. Group multiple receivers onto a single channel on your remote, or create zones by assigning receivers to one of four channels. This allows independent lighting control within a room or throughout the building.

Easy Set up:

Connect your LED strip light to the receiver unit by matching the connections to the markings on the unit. - = negative wire / + = positive wire

Connect your power supply to the receiver unit with the power off.

Insert sufficient batteries into the handheld controller. 

Turn the power on to the transformer, then within 3 seconds press any of the zone keys on your controller. Your LED lights should flash to signal a successful pairing with that channel.