Chrome Extending Bedside Reading Light - Low Energy

Product Ref: 2035 Do you have this item in black or any other similar light in black please.
This item is not available in black. We would suggest looking in our Bedside Reading Lights category for any other suitable fittings.

Is the Bedside Reading Lamp #2035 able to connect with US 110/120 volt power?
This lamp is only for 230/240 volt power.

Do you also ship to Germany? And if, has this wall light to be mounted on the wall or has the technical part to be inside the wall?
We can ship to Germany. If you place an order we will get back to you with the shipping fee. The wall plate is surface mounted.

Can this light be wired into and operated from a bedside switch too?
This could be wired to your mains switch, just make sure the rocker switch is on, then you would be able to control from your bedside switch.

Three questions, is this mains voltage? Does the plate fit flat to the wall? Is there any side profile pictures I can view?
Yes this is mains voltage. It projects 25mm, it hides a back box (housing the electrics/ connector box) and we have added a new picture showing a side profile.

is the light from the TS3863CC gentler and more subtle than that produced by one of the LED reading lamps which can be a bit harsh? Is is suitable to be mounted on the side of a headboard/cabinet rather than the wall behind the bed?
Yes the light from a CFL lamp is softer due the larger luminous surface. It`s close to incandescent. Some LED lamps are a little "sharp" and the colour temperature can be too blue. The product is "F" marked meaning it can be mounted on normally flammable surfaces i.e. wood safely.

Does the face plate fit flush to the wall or is proud of the wall. If proud of the wall what depth is it from the wall?
The face plate hides a back box (housing the electrics/ connector box etc), with a depth of 20mm.

I want 2 of these lamps to fit onto a wall either side of a dressing table mirror to give a good strong light onto my face when making up. Are these suitable?
Yes they`d give you a good amount of light however just be aware the light source is fluorescent so skin tones will not look as warm as incandescent light.

This lamp may be what we are looking for. Three questions: 1) Presumably the two arms each bend in two directions? 2) If so, how long is the `reach` of the arms from the central fixing point if the light is extended straight out? 3) Does the head of the lamp rotate to an angle, or is it fixed as shown?
Both hinges rotate 180 degrees. At full extension the centre of the lamp (bulb) is 345mm from the wall. The head rotates and tilts.

I am interested this bedside lamp but as a plug in alternative as all wiring & decorating has already been completed & we do not have in built wiring for either side if the bed . Any suggestions?
With a sharp drill bit (following an initial pilot hole) you could quite easily drill a hole in underside of this mounting plate. Protect your ingoing flex with a rubber grommet and connect up to the terminal block inside. There is a covering fascia plate to the front that would hide any imperfect DIY skills.