Continuous Line Pro HD LED Tape - Colour Correct CRI 90 White

Chip on board (COB) technology does away with individual semiconductors so light-emitting diodes can be closely spaced and covered with a phosphor coating. This technology aside, the net result is continuous intense light with no dotting.

From a distance, the continuous LED product is similar to a gas neon tube. It has all the benefits of neon but is smaller, dimmable, cooler, user-friendly, low voltage and can be installed by anyone, anywhere on site. 

These are medium-output tapes providing approximately 928 lumens per metre and are dimmable. The minimum bend radius is 30mm - cut and solder at tighter angles.

Offered here as 5-metre reels with pre-soldered lead at each end or by the metre (any length up to 5 metres) with a single pre-soldered lead. Multiple lengths of tape can be connected to a single power supply but we do not recommend any single length exceeding 5 metres. 

Rated at 11 watts per metre. A 24-volt power supply is required. The total load is obtained by multiplying the length in metres by 11 watts - a 5-metre length needs a supply of at least 60 watts.

The continuous tape has over 500 leds per metre. CRI<90 30mm cutting distance.

8mm wide maximum 11.2 watts per metre, typical 10 watts per metre.

Soft warm white 2700k
820 lumens per metre (82 lumens per watt)

Warm white 3000k
900 lumens per metre (90 lumens per watt)

Neutral white 4000k
980 lumens per metre (98 lumens per watt)

Daylight white 6500k
1000 lumens per metre (100 lumens per watt)

Requires a 24V DC constant voltage power supply. Suitable drivers are listed below.

We recommend using a heatsink if this tape is not installed in an aluminium profile. Installation onto insulated materials or tight spaces without a heatsink will drastically reduce the life of this product and invalidate the 5 years warranty. 

Please add a comment to your order (in the basket) if you require specific lengths.