LED lighting is a great way of getting mood lighting in your bathroom and these sealed LED strips have 96 super flux LEDs in each 1.0 metre length.

We offer these in two sizes with two wattages. Available in and 1000mm (12w) - 3000°k which is a warm white.

These circuit board mounted LEDs are mounted in an aluminium profile which is sealed with synthetic resin to IP55.

We supply these as an installer kit which includes the LED strip, a 5.0 metre feed-in cable and a 24 volt 12 watt power supply.

Can be easily wall or ceiling mounted - just add the pack of ten to your basket when ordering. The plug and socket connection is between the DC power supply and the led lights - it is a push fit connection.

60 degree beam angle.

IP55 rating safe for use in zone 1: waterproof and safe.

Number Of Lamps	72
Lamp Type	Long Life LED Light Source
Lamps Included	Yes
Dimmable?	No
Max Wattage	8w
Width	20mm
Height	15mm
Construction	Aluminium - Anodised
Wiring Details	Class 3 - Requires a low voltage supply
IP Rating	IP55
Kelvin	3000°K - Warm White
Driver	Includes integral driver/transformer suitable for 230 - 240v supply

In a small en-suite wet room shower measuring 1700x1300 will a 1000mm strip offer enough light?
This is more for mood lighting, and would recommend another source of light to be used too.

Is a diffuser available for this LED strip? Is the strip designed to be visible or hidden from view?
There is no diffuser with these. They come as the picture suggests. Tbf they can be both, They are attractive enough to be shown, or if you wish to hide them you can.

Can these be fitted in zone 1 of a bathroom? I am thinking of fitting it into shower enclosure ceiling.
Yes this would be a perfect application for this product.

Can the lengths be cut? I need more than 1 m not less than 2m
The lengths can not be cut, they have to be kept at the standard length.

If using these lights in the bathroom, surely they are illegal if you need to plug them in? Or at least it would be unsightly to have a cable running out the bathroom door to the nearest socket in the hall. Solution?
What we have written has been misinterpreted. The plug and socket connection is between the DC power supply and the led lights, it is a push fit connection. It does not have a trailing lead with a 3-pin plug on the end. The power supply is listed below the product. This should be located out of the way i.e. under a bath or in the roof space. The electrical (mains AC incoming) connection to the power supply should be hardwired i.e. carried out by your electrician and typically installed on the switched lighting circuit or via a fused spur. Between the DC power supply and the LED strip you will require a power lead (also listed below). This is hard wired to the secondary (DC) side of the power supply and connected to the LED strip with a push fit connection.

IP55 LED Strip 1000mm Long

Sold as Kit with Everything you Need

Related Categories