Aluminium Under Cabinet Light - Pack Of 3

Are this suitable for fitting at the front of the cabinet, behind a pelmet. Also, when fitted like this, would the light be pointing back and downwards at 45°?
The profile can be fixed 45º angle at the wall shining out, at the front behind a pelmet shining back, or can be fixed shining down in any position.

We are considering having 3 x SW9239 units beneath 3 isolated cupboards. We cannot put a transformer with each light. Can a single 250va transformer be put adjacent to the switch. Cable lengths 4m + 4m + 3m, 1.5mm twin & earth.
The load of each fitting is negligible any voltage drop on the secondary circuit would be hard to notice at the fitting. A good solution to your situation.

Is there any buzz associated with this fitting? My noise from my current strip lights is so intrusive I don`t have them on!
If the power to the transformer is switched rather than dimmed there should be no noise at all from the fixture or transformer. Occasionally when dimmed on cheaper dimmer modules a slight buzz may be heard.

We currently have pyramid style lights under cupboards but they continually fail and when try to change bulb (even electrician doing job) the casing shatters as it has become brittle. Can you tell me how easy it is to replace the bulbs on this style of light?
The casing shatters on your existing fitting as a result of UV and heat from the lamp. The diffuser on these lights is open at either end reducing heat build up. The diffuser slides along the profile to reveal the lam and lamp holder. The lamp has two pins and just pulls out for easy replacement. Once replaced the diffuser slides back into place. No tools are required.

Where do you stock the bulbs?
The fitting comes complete with lamps. Spare lamps are listed at the bottom of the page.

Does this light fit to the wall or to the cupboard?
The fixing clips allow this profile to be fixed in thre ways: screwed to wall at 45° screwed to cupboard at 45° screwed to cupboard shining straight down (front or back)

I need to know how this unit is powered, i.e. does it have a plug attached or is it connected to the power in another way?
This unit requires a 12v supply. Often a transformer can be located on top of a kitchen cabinet. Route the trailing lead on the light fitting behind the cabinet and connect to the transformer.

How bright is 20 Watt G4 Halogen? Is this same as standard bulb or is this good light coverage?
A 20w G4 halogen lamp is equivalent to a 30w tungsten filament GLS lamp. But the light is crisper white with better colour rendering i.e. colours look more vibrant.

How do you connect 2 of the 600mm under-shelf lights, either side of the cooking hob, to a single transformer? Or do I need 2 transformers? Transformer will probably be sited above the cabinets near a suitable mains socket.
In this instance we`d opt for two transformers. Locating these on top of the cupboard will give the neatest solution.

Is this unit dimmable?
These lights are dimmable when used with a dimmable transformer (and most of them are).