A 2000mm long track available in black, white or satin nickel.

Track lighting is ideal for use in commercial settings where strong direct light is important such as retail displays in shops, or it can be used in office areas as task lighting, however it is not limited to use in these areas as it is also perfect for use in the home, kitchens, for example, can benefit greatly from the light that track systems offer, providing light to food preparation areas or as a customisable alternative to standard spot lights

Each length of track is supplied with a dead end and a live end.

Simply screw your track to your ceiling, wire into your mains supply and you're ready to put your chosen fittings on to the track.

There are a number of different fittings and accessories available for the track. These can be found at the bottom of this listing. or in the basic mains track category.

Also available in 1000mm and 3000mm.

Track Compatibility
	Aesthetic Domestic Track System
	Basic Mains Track
	Commercial-Grade 3-Circuit Track Lighting System
	Low Voltage Tension Wire Components
	Luxury Magnetic Light Track 48v
	Signature Recessed Track System
	Signature Single Circuit Track System
	Track for Suspending Pendants

Lamp Type
Dimmable?	Yes - on standard dimmer (TRIAC or leading edge)
Width	35mm
Length	1000mm
Height	17mm
Construction	Metal
Wiring Details	Class 1 - Requires an Earth Connection
IP Rating	IP20

Can this track be curved to fit to a circular rail
This track cannot be curved, Just Straight lines.

Can this track be fixed to a wall rather than a ceiling?
Yes in theory this can be used on the wall rather than the ceiling.

I want to create a closed rectangle with the track with the power supply starting centrally on one of the long sides. Does this system allow you to close the circuit or must there be a break in the line somewhere?
There has to be a break in the line with this track. You could still make your rectangle, you just wouldn't close up one corner.

Can I buy a plastic/rubber profiled strip for filling in the empty track slot once installed to reduce risk of electrocution to near nil?
There is no plastic/rubber profiled strip for filling in the gaps. We would advise that you do not touch the track when installed and on.

I want to install a 2000mm track with power to the centre, and 6 lights. Do I need a track feed in addition to the track MLTRK2. If so do I also need to replace the live end supplied with a second dead end?
Yes, so altogether you`ll need, 2 x 1 metre tracks (Or cut a 2 metre), a track connector, and 2 dead ends (1 included with each length of track)

Do you have suspension rods for this track system (white)
This track is designed to be flush to ceiling, and there is no suspension rods available.

I want to put up to 8m of track in a cinema room. Is there a maximum load each 2m section would carry?
With this beings a mains track you could have as many as you wish.

Can a 2m basic 230v lighting track be shortened ? Just purchased one really need 1.5 m track could you please advise?
Yes. For ease install the power feed onto the track (don`t connect the electrical supply!). Once fitted and screwed tight remove the end cap from the other end of the track. Cut the track to length with a mini hacksaw or mitre saw. Once cut you`ll see that the copper conductors either side of the track will need to be trimmed back a few millimetres so the end cap may be fitted (this is a safety requirement). Removing the power feed makes it trimming conductor easier.