LV Tension Wire Tensioner/Holder (Pack 2)

A 2 piece pack of holders/tensioners for low voltage tension wire systems.

Affixed to your ceiling or wall your wire is clamped into these holders which can then be adjusted to increase tension in the wires and prevent sagging.

Polished chrome finish.

• Pack of 2
• Chrome Plated
• For Use With LV Wire

Specification
Width/Diameter	50mm
Height	100mm
Construction	Steel with Chrome Finish
Wiring Details	Not applicable

Availability: Normally in stock - delivered in 5-7 days

Could you please tell me if i would need to have any additional cable supports if i had a 7 metre run of 6mm tension cable with 6 pendent lights (50 watt lamps) with just a wall mounted wire tensioner at each end and? The lights would be fitted in a conservatory. If the design above were to be installed by two big chaps you could set this up without any intermediate supports. You'd fix the wire at one end with the tensioner at it's longest setting, then pull the wire as taught as possible, position and tighten the clamp on the opposing tensioner and screw both ends up till the wire is taught. I say two big chaps as there is a little stretch in the wire so you'll need to get it at tight as possible before using the tensioners (each tensioner will adjust 20mm). So your system would need enough wire for the run (x2), two addition lengths to connect to the transformer, a 300va transformer, two tensioner packs, six lights of your choice and a set of feed-in connectors. But there is a potential problem if your fixing positions are on uPVC conservatory where there is a steel structural member behind the uPVC. You'd need to isolate the 12v supply for the fixing screws or the whole system will short-out on the metalwork. Call us for details if you like further assistance.