Dual Voltage Low Energy Shaverlight

A punchy low energy over mirror shaver light with built in shaver socket. Supplied complete with 18w single turn compact fluorescent lamp. Lamp runs on HF flicker free control gear. Lamp supplied.

Important note: On this shaver light there are six screws on the back and one under the diffuser - we get a number of calls asking how to get into it. To connect to the incoming mains DO NOT REMOVE THE SCREWS ON THE BACK, remove the diffuser, remove the lamp and unscrew the flap behind the lamp. Here you'll find the connection terminals.

• 110v and 240v outlet
• Great for shavers and toothbrushes
• Has removable chrome end caps
• Pull cord operation - suitable for zone 3

Specification
Number Of Lamps	1
Lamp Type	2G11 4 Pin
Spare Lamps	2G11 Base PL-L Compact Fluorescent Lamp
Lamps Included	Yes
Max Wattage	18w
Width/Diameter	385mm
Height	60mm
Depth/Projection	70mm
Construction	Acrylic
Wiring Details	Class 1 - Requires an Earth Connection
IP Rating	IP21

Availability: Normally delivered in 3-5 days

Will it continue to charge an electric toothbrush when the light is switched off? In short yes. The power supply to the shaver socket is independent of the light itself and so your toothbrush will happily charge when the light is switched off. Unless of course your light is off due to a power cut.

Can the shaver socket be used without the light being switched on? Yes, this is a common question, the power supply to the shaver socket is independent of the light and so your toothbrush will happily charge when the light is switched off. Unless of course your light is off due to a power cut!

As I am replacing an existing light, the wire already comes through a hole in tiles. Will I still have flexibility in being able to position the light and not have problems because the mains wire comes out in a different place than that required by the light? The mains exit point is located centrally to the back of the fitting, the rest depends on where your existing mains supply wire is.

I was looking at the Dual Voltage Low Energy Shaverlight TOMSH1844DVO. Can you indicate the separation of the fixing holes and how they are accessed (I'm also replacing an existing light). The Cable entry is in the centre of the back plate. The fixing holes are 178mm apart (approx 7"). The fixing screws are accessed once the front diffuser is removed.

1) Does the unit connect to the wall via 2 screws? If so, how far apart are they? 2) My existing wall light only has red/black cables coming out of the wall, so no earth. Do you have any suggestions? 1) Yes it connects to the wall via 2 screws - These holes are 178mm apart (approx 7"). 2) You should choose a double insulated light fitting. The following shaver lights are double insulated MIK0275 & MIK0598.